Excessive fired shrinkage causes dimensional accuracy problems β tiles come out smaller than the die size, making them incompatible with specification tolerances or mix-and-match requirements.
Excessive fired shrinkage causes dimensional accuracy problems β tiles come out
The primary flux-related cause is over-fluxing: too much nepheline or feldspar creates excessive glass phase that pulls the body together more than intended. If you recently increased nepheline content or switched from feldspar to nepheline without reducing the percentage, the additional flux is causing extra vitrification and therefore extra shrinkage
Fix: reduce nepheline by 2-4% and compensate with quartz (which does not contribute to vitrification and has low shrinkage). Or reduce firing temperature by 10-20 degrees C if your water absorption still meets specification
See product recommendations below
Understanding This Defect
The primary flux-related cause is over-fluxing: too much nepheline or feldspar creates excessive glass phase that pulls the body together more than intended. If you recently increased nepheline content or switched from feldspar to nepheline without reducing the percentage, the additional flux is causing extra vitrification and therefore extra shrinkage. Fix: reduce nepheline by 2-4% and compensate with quartz (which does not contribute to vitrification and has low shrinkage). Or reduce firing temperature by 10-20 degrees C if your water absorption still meets specification. Note that nepheline requires approximately 15-20% less weight than feldspar for the same flux effect β overshooting the conversion ratio causes the excess shrinkage..
Solution & Prevention
.
Experiencing this defect?
Send us a photo of the defect + your current formulation. Our team provides free troubleshooting support.
